Maintaining Your Lawn Mower

posted by HomeDepot.com

 

Maintaining Your Lawn Mower

There's more to mowing a lawn than just turning on the mower. A mower that's not properly cared for will have years taken off its life and have a lot more problems in the short run, as well.

A little fast, simple maintenance during the mowing season and just before you put it to bed for the winter can make the difference between care-free operation and lots of costly and stress-inducing problems.

Be sure to keep the blade sharp, as described in the project Sharpening a Mower Blade. A sharp blade, along with a well cared-for engine, will keep your mower humming for years to come.

Steps

Steps 1 - 6 of 6

• 1

Step One

Keep it clean. After each use of the mower, give it a quick brushing off with a gloved hand or rag or whisk broom. It’s a good idea, too, after the mower has stopped running completely, to reach under the deck with a gloved hand and do a quick brushing off of caked grass under the deck and on the blade.

Step Two

A couple times a year, give the mower a good cleaning. With the gas tank empty, turn the mower on its side. Remove any debris that may be wrapped around the blade or caked up on the underside of the mower deck. Spray the underside of the mower deck hard with a garden hose to loosen dirt and dried-on grass. Scrub with a soft brush and soapy water. Then rinse.

Step Three

Clean or replace the air filter once or twice a year. Replace paper filters when they look dirty (keep a few on hand). Plastic foam filters should be removed and washed with warm, soapy water. Air-dry thoroughly. Then work about 2 tablespoons of clean mower oil evenly across the filter to lightly coat it.

Step Four

After you’ve used the mower for the last time at the end of the growing season, empty the fuel tank by letting the engine run until it is out of gas. Leave the gas tank empty until spring. With the gas tank empty, remove the oil fill cap (if applicable) and turn the mower over to drain the engine oil into a suitable container for recycling. If your mower has an oil drain plug, use that instead of turning the mower on its side. Refill the engine oil reservoir per your mower manufacturer’s recommendations, then replace the oil fill cap.

Step Five

Once a year when you change your mower’s oil, replace the spark plug. Disconnect the spark plug wire, then remove the existing spark plug with a wrench or pliers. To ensure you purchase the right replacement plug, write down the code on your existing plug, consult your mower’s owners manual, or just take the old plug with you when you go to purchase a new one. Screw in a new plug, then reconnect the spark plug wire.

Step Six

Keep the blade sharp. A dull mower blade cuts unevenly and shreds the tip of grass blades, which then turn brown and give a lawn a beige cast that makes it look dry. The ragged ends are also good entry points for disease.